• Author : JOONHWAN CHO

 
 

IFP slice alloation

I want to know about  IFP Slice allocation rules. I  have done show hardware capacity but some slice has been used 100% and some slice has been used 0%. so i want to share it. I think that ipv4 allocates some slice, ipv6 allocates some slice.   In my customer sites, there are many ACL, PBR. There is exceed a capacity now So, I can’t add anymore entry of ip access-list. I have to optimize ACL, PBR  LIST because  it can’t add it. Could you please explain how to  optimize it? Please refer to attachment. In advance , Thanks.  ...
Continue reading →

Recursive PBR

I have tested Recursive PBR. first of all, I know that when I apply to physical interface, it is normally operate it. But I have tested below test. so I think that it is now operate it….. I want to test  Recursive PBR that operate interface vlan 100 in  physical interface 34. but In this case, it is not normally operate it. some case, when I apply Recursive PBR to interface VLAN 100, it is normally operate it. Please refer to below contents. If you need  more detailed information,  configuration and network diagram,  please comment it. In advance, Thank you....
Continue reading →

lacp port-priority

Hi. I want to know how to test lacp port-priority. I check show lacp neighbor  and  change port-pritoiry. ex)there is port 1,2,3. port 1,2 priority is 100, port 3 priority 3 is 1000. but  port 3 doesn’t change  standby port. How to  change port 3 standby port ? or test it? In advance, thanks.  

LACP port-priority test

I want to know how to test lacp port-priority. I check show lacp neighbor  and  change port-pritoiry. ex)there is port 1,2,3. port 1,2 priority is 100, port 3 priority 3 is 1000. but  port 3 doesn’t change  standby port. How to  change port 3 standby port ? or test it? In advance, thanks.  

Follow

Get every new post on this blog delivered to your Inbox.

Join other followers: