• Author : Peter Fordham

 
 

Storm control in packets-per-second

The existing storm control interface configuration mode CLI commands have been extended to support the new configuration option Packets per second (pps) on the following platforms: 7050X 7050QX 7300X Configuration The existing percentage parameter command limits the broadcast/multicast traffic to a specified percentage¬†of the link-speed as mentioned in the command. Following is the example command. Arista(config-if-Et1)# storm-control broadcast level 50 The above command can be replaced with ‘pps’ followed by the allowed number of packets per second. So, instead of limiting broadcast traffic to 50% of the link-speed, the command below will limit the broadcast traffic to 5000 packets per...
Continue reading →

Follow

Get every new post on this blog delivered to your Inbox.

Join other followers: