Posted on January 11, 2017 5:47 pm
 |  Asked by Thananchai Panyatavahirun
 |  971 views
0
0
Print Friendly, PDF & Email

Such as

SW1
interface Po10.100
encapsulation dot1q vlan 100
no switchport
ip add 10.0.0.2/24
ip virtual-router address 10.0.0.1
!
ip virtual-router mac-address 00:1c:73:00:00:99

SW2
interface Po10.100
encapsulation dot1q vlan 100
no switchport
ip add 10.0.0.3/24
ip virtual-router address 10.0.0.1
!
ip virtual-router mac-address 00:1c:73:00:00:99

 

0
Posted by Tyler Conrad
Answered on January 15, 2017 10:20 pm

From Arista warrior:

VARP cannot be configured on routed Ethernet interfaces, including the management interfaces. It is only configurable on VLAN interfaces. While the Arista Configuration Guide doesn’t specifically say that it won’t work on Ethernet interfaces, to be fair, it only mentions VLAN interfaces in the VARP section. If you need first hop redundancy on physical interfaces, you’ll need to use VRRP.

 

Could be out of date, since it was written in 2012. Is creating a vlan on both switches and running vARP on the SVI an option?

Post your Answer

You must be logged in to post an answer.