Posted on October 12, 2015 11:39 am
 |  Asked by Albert Albert
 |  1700 views
RESOLVED
0
0
Print Friendly, PDF & Email

I have the following setup in the Lab (See Attached PDF).  I am able to discover and learn new switches reside in the Production Network but Lab switch is stuck in a looping state.

After the lab switch received a DHCP assigned address and downloaded the script, it tries to execute the script which it keep sending request to CVP’s eth0 IP.  Since the Lab switch has no route to the Lab External segment, it just stuck in a loop.

 

My question is

Can CVP be configure to use eth0 IP for devices in Production Network and use eth1 IP for devices in the Lab Network?

 

Thanks

 

0
Posted by vipul
Answered on October 12, 2015 10:55 pm

I believe we are responding to bootstrap requests with the ’eth0’ IP address so this is not doable at this point.  We will file an RFE for this feature to be available in the upcoming releases.

I have a similar issue but ZTP request are being sent to eth1 instead of eth0 – and the device stuck in the loop after DHCP.

During the console setup, CVP was configured with eth0 address – yet ZTP picks up eth1 IP address.

Can we nail up which IP address/interface that ZTP can use?

(Joe Khine at November 10, 2015 7:06 pm)

Post your Answer

You must be logged in to post an answer.