Posted on July 1, 2014 11:20 am
 |  Asked by Amy
 |  13775 views
Tags:
RESOLVED
0
0
Print Friendly, PDF & Email

Hi all,

I want to configure dynamic nat, PAT, on my 7150s running 4.12.7.1, but haven’t had any luck getting the translation to work.

I have tried a few configuration variations, but the following is the one I believe should work.
Any suggestions? What am I missing? I want the source address to translate to the address of the SVI:

IP Access List nat1
 10 permit ip 10.200.250.0/24 50.112.0.0/17
interface Vlan14
 ip address my.pub.lic.ip/31
 ip nat source dynamic access-list nat1 overload

Thanks in advance!

0
Posted by Alexis Dacquay
Answered on September 24, 2014 10:00 pm

Hi Amy,

As per your other post ”NAT Overload”, your configuration seem correct, depending on routing, ARP, MAC addresses being also correct.

Check out this post for troubleshooting tips.

 

Regards,

Post your Answer

You must be logged in to post an answer.