Posted on June 10, 2021 7:11 pm
 |  Asked by Kirils Zaicenko
 |  22 views
RESOLVED
0
0
Print Friendly, PDF & Email

Hello!

Is it possible to limit on which interfaces DHCP requests for ZTP will be sent?

If not, then what is the order in which the requests are being sent? For example, management ports, then other ports?

Can boot-config NET commands be used to affect ZTP behavior? For example, if I set NETAUTO=dhcp only on one interface, will ZTP requests be sent only on that interface?

Thanks!

0
Posted by Kirils Zaicenko
Answered on June 11, 2021 4:56 pm

I've got a response from support, stating that there is no configuration option to specify on which interfaces ZTP DHCP requests will be sent.

So, basically, the only option is to instruct the operator to disconnect unwanted ports prior to provisioning.

Hopefully, the ability to configure this behavior will be added in the future releases.

Post your Answer

You must be logged in to post an answer.